2021-09-03

Honeywell Controller Project

---

Overview

// 'HWCONFIG'

Is a filesys that contains the actual ".XML"

Containing the actual:

• "modulating controller"

  &&

• "installer settings"

(Procedure for Dual Systems)

• Load installer settings from the USB connection.

• On your primary (ie largest connected to controller) air unit.

• MY primary happens to be on my 1st floor. Ie MY "downstairs" controller.

• Then load this versioning. To your secondary (MY "upstairs") controller.

• To ensure a syncronized at the primary

  • Airs Circulation

    &&

  • Fire Suppression Controls

• Which is then what's used for the below 'HowTo'

// Honeywell Firmware

Website: https://thermostatsetup.com/thermostat_setup/en/prestige/software

• downloadLink (1)(v-Advanced-Controller)

  'https://thermostatsetup.com/thermostat_setup/en/prestige'

• downloadLink (2)(v-Basic-Controller)

  'https://thermostatsetup.com/thermostat_setup/en/vision_pro'

  (1)

  This ^ one is used to error the controller's maintenance mode.

  Allowing a manual selection for the manufacturer.

  To flash software && over-ride in appropriate "good faith".

  (2)

  It is included in the filesystem.

  That you fork from this repo.

  To proceed.

---

/* Instructions on HowTo Flash Honeywell Controller */

// 0

Remove battery from back on the "Honeywell Controller"

// 1

Plug flash drive into the bottom of the controller

// 2

Hit -> 'Load installer settings'

// 3

Enter the installer password Note (1)

• Is the "Date Code"
• Listed in the details
• For installed controller (in the UI) Note (2)
• Date code is '1850'

// 4

Load the contents of -> / HWCONFIG /

Specifically the "XML" file of -> 'ISUCON00.XML'

Displayname: 20210703installerSetupDownloadToUsb

• ^ Should be shown on UI

Model: THX9001R5029

• For ^ model of the Honeywell Controller

// 5

Select the displayed

-> Configuration

--> '20210703installerSetupDownloadToUsb'

There is a single selection. Corresponds to the 'ISUCON00.XML'.

// 6

Load '20210703installerSetupDownloadToUsb' as the firmware.

For this installation as an "installer". To your controller.

Ie

• You are overwriting the previous "configured" firmware

• With MY '20210703installerSetupDownloadToUsb' versioning

• MY default is

  // Configured for my epilepsy + neuropathy

  🔃 onLoad 🔃

  // Is
  -> Unlocked
  -> 75 min && 82 max
  -> Recurring scheduled (Twice daily)(0200 && 0700)

// 7

In Review

• You should have...

  [✅] Reset your Honeywell Controller

  [✅] With '20210703installerSetupDownloadToUsb'

• You should be...

  [✅] Looking at an unlocked screen

  [✅] Looking at an unlocked screen with full interactibility

  Of

  ▶ "UI Elements"

  ▶ "Mutability" (Displayed Values)

• If this resolves to...

  [✅] 'TRUE'

  [🥳] Congratulations! You've succeeded!

---

LICENSE

Honeywell Controller Project - README.md
2021-09-03
v.1.0.0

MIT License
Copyright (c) 2021 Jeffrey Bodin

---