[Lab Experience] SDN Security

About the project

BonsaiLab@Politecnico di Milano - 2021/2022

Implementation of a Software Defined Perimeter (SDP) in Ryu manager: in order to access a service inside a network, a client must authenticate itself by sending an authentication request to the network controller. The authentication is based on a Hash-based Message Authentication Code (HMAC) computed using a pre-shared key. Sequential nonces are used in authentication requests to avoid replication. Once the authentication is successfull, the controller setup a connection between client and server on the shortest path.

sequenceDiagram
Client->>Controller: Send the Auth Request
Controller-->>Controller: Check if the Auth Request is authorized with the valid nonce
Controller-->>Controller: Install flow entries from client to server
Controller->>Client: 202 Authentication Accepted
Client-->Server: Connection Setup

Loading

The sdnsec.ipynb notebook is just a draft containing the code used for the SDP authentication part.

Before running

Run create_conf.py at client (in ~/ folder) and controller side (~/ryu/ryu/app/ folder). The following parameters can be set:

• In sec_controller.py:
  • self.flows_expire_in (default = 30): expiration time (idle_timer) in seconds of the flows entries installed through authentication
  • self.ctr_margin (default = 5): nonce(counter) acceptance margin
  • self.controller_mac (default = "4e:4e:4e:4e:4e:4e"): dummy MAC address of the controller
  • self.controller_ip (default = "10.0.0.100"): dummy IP address of the controller
  • self.servers_ip (default = ['10.0.0.2']): list of servers which can be reached through authentication
• The following conf_dict values in create_conf.py:
  • "controller_ip": dummy IP address of the controller
    • "auth_port": UDP port where client address its Authentication Request
    • "master_key": master key from which are derived client and controller shared keys
    • "next_ctr": next nonce to be used for a valid authentication request
• In clientsec.py:
  • max_nb_attempts (default = 5): maximum number of failed Auth Requests, can be increased up to 15 in case of non valid nonce
  • reception_timeout (default= 2): maximum waiting for the response
  • server_ip (default = '10.0.0.2'): IP address of the service for which client wants to request the connection
  • server_port (default = 22): destination port address of the service for which client wants to request the connection
  • conf_path = conf_path = ~/conf.json
  • transport_layer (default = 'tcp'): transport protocol that want to be used to communicate with the service

Running on Mininet

1. Run Mininet with a topology of your choice (e.g. the one described in ~/TwoWayTopology.py) sudo mn --custom ~/TwoWayTopology.py --mac --topo mytopo --controller=remote,ip=127.0.0.1,port=6633 --switch ovs,protocols=OpenFlow13
2. Run Ryu manager ~/ryu/bin/ryu-manager --observe-links ~/ryu/ryu/app/sec_controller.py
3. Send at least a packet from servers in order to trigger the MAC learning on controller (through a ping for example)
4. Open server terminal on server through xterm h2 and run server application on it ~/server.py. Supposing h2 is the server host and server.py is placed in its home folder.
5. Open client terminal on client through xterm h1 and run client application on it ~/client_sec.py. Supposing h2 is the server host and client_sec.py is placed in its home folder.

At the end of this process, a connection between client and server is setup if everything went correctly.