EscapeKeeper Setup

Also see the quick start guide, and the manual.

Each junior is set up to connect to the next junior in link mode on output 1, a group of five LED buttons on output 2, and a 12v relay on output 3, which powers a 24v maglock. The first junior powers its its own buttons with the power terminals, the last junior does not power any buttons. Each junior is powered with in parallel with a 12v5a dc power supply.

Each junior will wait for its five inputs to open in order, open the maglock for a second, close the maglock, and then enable the next keeper and power its inputs. This way players progress through the puzzle five inputs at a time, and they can see the next five light up after each section is solved.

Game modes

1. Hold button 3 and plug the 12v dc power cable into the side of the escape keeper.
2. Use the volume knob and button 3 to select the following indicators in order:

• 1
• 5
• 7
• 1
• 1
• 1
• none

Button sequences

1. Push all LED buttons in
2. Push REC
3. Push LED buttons in order
4. Push REC

Output animations

1. Push the next five LED buttons in
2. Hold REC and wait for the indicators to light up
3. Keep holding REC and use the volume knob to select indicator 6
4. Release REC
5. Tap REC
6. Push button 2 for one second, the mag lock should close
7. Release button 2, hold button 3, the next five LED buttons should light up
8. Keep holding button 3 and tap REC, then release button 3
9. Hold button 3 to save the animation, or go back to step 4 to record again