3D-printed HOTAS Joystick Soleil: F-16 Sticks + housing + twist rudder controls

Features:

• Removable stick
• Two different stick's size, improved stick's parts mounting, used other type of 5-way Hat/POV Switches
• Improved Gimbal parts mounting, corrected the dimensions of the holes for the bearings
• Two different types of housing, one with additional axes and toggles

3D Model

You can see the assembled 3D models in web:

• Short Size Stick

• Normal Size Stick

• Cylindrical JoyStick Base

• Rectangular JoyStick Base

Printing

• White and black PLA+, red PET-G
• Rafts: Yes
• Supports: Yes
• Infill: 20 - 30 - 60%

Components (not complete)

• Bearing 6802zz (15x24x5mm) - 5 units
• Bearing MF105zz - 8 units
• Bearing 685zz - 4 units
• Adhesive non-slip pad 200x200mm - 1 init
• The TLE5011/5010 sensors - 2 units
• Hall-effect sensor (SS49E for example) - 1 unit
• Ceramic capacitor 50V 104 100nF 0.1uf - 1 unit
• Cylindrical magnets (5x10mm) - 4 units
• 5-Way Switch 10x10x10mm Multi Direction Switch Touch Reset Button - 4 units
• Push Button 6x6 4.3mm - 5 units
• Miniature toggle switch (on/of/on or reset/of/reset ) - 2 units
• Potentiometer (WH148) 10K Ohm (B10K) - 3 units
• Switching Diode (for example 1N4148) - 30 units
• Micro-USB 5pin Micro USB 2.0 Male to USB 2.0 B Type Female Connector Cable 30cm With Panel Mount Hole cables - 1 unit
• Wires - 28-32 AWG
• Hot Glue - 1 unit
• Two Component Epoxy Glue or Super Glue- 1 unit
• Low-cost STM32F103C8 microcontroller - 1 unit
• FreeJoy soft and manual

Screws, nuts, etc…

• WiP - See the answer to the issue

Images

Video

If you find this design helpful, consider to support my work and my future projects. Thanks in advance.