Skip to content

Home

Jump to bottom
Peter-van-Tol edited this page May 21, 2022 · 2 revisions

This project aims to make a generic CNC firmware and driver for FPGA cards which are supported by LiteX. Configuration of the board and driver is done using json-files.

The idea of this project was conceived by ColorCNC by romanetz on the official LinuxCNC and the difficulty to obtain a MESA card.

Acknowledgements

This project would not be possible without:

  • ColorCNC by romanetz link;
  • HostMot2 (MESA card driver) as the structure of the driver has been adopted.
Clone this wiki locally