-
Notifications
You must be signed in to change notification settings - Fork 5
SD Stuff
luni64 edited this page Apr 26, 2020
·
1 revision
TBD
- HFW8R-1STE1LF
-
SFW8R-2STE1LF
Fits the solder pad layout on the teensy 4 but the lock tabs are a little too wide to fit between the header pins if used. The tabs are only plastic though and can be trimmed with a sharp knife/scalpel (see post)
It is expected that a Teensy 4.1 will be released that uses a Teensy 3.5/3.6 form factor and will include a micro-SD card reader.
Alternatives for bringing out the SD card pins on the Teensy 4.0.
Teensy is a PJRC trademark. Notes here are for reference and will typically refer to the ARM variants unless noted.