Common Configuration_en

Common Configuration contents

• Search
• Setting
• Firmware Upload
• Reset
• Factory Reset

Search

Open the configuration tool and click the 'Search' button.

If the board is turned on and connected to the same network, the MAC address and device name of the searched device can be checked from the configuration tool.

When you click on a device, each of information appears in the right pane.

Setting

'Setting' button is used to apply your configurations.
After changing the setting, press the button to advance the configuration.

• configuration setting success

  If the setting is performed successfully, you can check the following message displayed.

  

• configuration setting warning

  The device is responding but the response is not normal. (Incorrect response or include error message)

  

  In this case, check the following.

  • Device's firmware version

    If the device's firmware is old version, there may be a compatibility problem. Then please use the latest firmware version.

• configuration setting fail

  

  This occurs when no response from the device after setting.

  If you get the failure message, it may be due to the following causes.

• Invalid command

  This occurs when an out-of-range value or an invalid value is entered.

  You can check the parameter that caused the error from the pop-up.

  

Firmware Upload

You can upload the firmware binary file from 'Upload' button.

Binary files can be found in the WIZnet github product repository or S2E Documnet page.

About WIZ750SR, refer to below links.

Get WIZ750SR Firmware

• Official release version

• Development version

  The following pop-up will appear if the firmware upload is complete.

  

  When do device's firmware upload, use TCP port 50002 to upload firmware to the device.
  Firmware upload can be unsuccessful due to firewall or virus protection software.

  In this case, try to upload after turning off the firewall or virus protection software.

  Please refer to this guide if still unsuccessful.

  • Troubleshooting Guide: Firmware cannot be uploaded

  The module will not work properly if the firmware is not correctly uploaded.

  WARNING: DO NOT TURN OFF POWER DURING FIRMWARE UPLOADING IT CAN CAUSE MALFUNCTIONING

Reset

Option for reboot the device.

If you press the 'Reset' button, the confirmation window will appear like below.

Press 'Yes' button to reboot.

Factory Reset

This is for initializes the device to the factory default state. Factory reset will reset all settings.

If you press the 'Factory' button, the confirmation window will appear like below.

Press 'Yes' button to proceed factory reset.

The device will automatically reboot after the factory reset.