Usage

Here's how to use this bot in the Discord server.

• Bot Name: obs-hub-control
• Channel: #obs-hub-control

You can only interact with the bot in the designated channel.

Most of the time, you will interact by clicking on the bot's UI, but there are also some slash commands.

Bot UI

Conventions

• Blue buttons affect the preview scene
• Red buttons affect the program scene

UI Elements

Preview Scene Up	Preview Scene Down	Timetable Manual Retract	Timetable Manual Advance

Set dB of media source in preview scene to specified value

Play/pause preview media	Reload preview media	Autoscale/center preview media	Lower preview media volume by 0.5 dB	Raise preview media volume by 0.5 dB

Not implemented

Play/pause program media (you should never need this)	Reload program media (hope you should never need this)	Trigger Automated Transition	Lower program media volume by 0.5 db	Raise program media volume by 0.5 dB

Automated Transitions

This is what you're here for.

1. All sources other than the current playing source in the program scene and Master should be muted and at 100% volume
2. Set the preview dB to the desired target volume (usually at a level where it peaks at -20 dB on AniCLover's setup)
3. Transition Target Volume will be automatically updated to be the preview dB
4. Click
5. Audio will begin crossfading between the program and preview scene right away*
6. After a delay of Transition Visual Delay, OBS scene transition will start and timetable advance will be triggered. If the preview media is local (e.g. a recording), it will begin playing when the OBS transition is triggered.

[*] "Crossfade" means the preview volume will go to 0%, unmute, and then gradually increase to Transition Target Volume while the program volume simultaneously goes to 0% over a duration of Transition Crossfade. After this is complete, the new preview source will be muted and brought back to 100% volume.