Icezum Alhambra

Arduino/zum compatible Open FPGA electronic board. Synthesize hardware easily, using only open source tools

Features

• FPGA development board (iCE40HX1K-TQ144 from lattice)
• Open hardware
• Compatible with the opensource icestorm toolchain
• Arduino like board: similar pinout than Arduino one / BQ zum.
• You can Reuse most of available shields
• Control your robots / printbots from an FPGA
• 12 MHZ MEMS oscillator
• ON/OFF switch (turn off your mobile robot easily)
• Input power voltage: 6 - 17v
• Max input current: 3A (Perfect for powering your robots)
• 20 Input/output 5v pins
• 8 Input/Output 3.3V pins
• USB micro-B connector for programming the FPGA from the PC (same than zum board)
• FTDI 2232H USB device allows FPGA programming and UART interface to a PC
• Reset pushbutton
• 8 general purpose leds (user leds)
• 2 general purpose pushbuttons
• 4 analogue inputs though I2C bus

Documentation

The project documentation is located in the wiki

Author

• Eladio Delgado Mingorance

Credits

• María Delgado Mingorance
• Juan González
• Design derived from the zum core board by BQ
• Design derived from the Icestick by Lattice
• Icestorm project, by Clifford Wolf and Mathias Lasser

License

Licensed under Creative Commons Attribution-ShareAlike 4.0 International License