Skip to content

ericvb/Raw-IR-decoder-for-Arduino

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

IR decoder

Decodes long IR codes, for example from air conditioner / heat pump devices.

Shows the timings, the symbols, and also the decoded signal for certain air conditioners.

Required hardware:

  • Arduino (any compatible will do, but Arduino Uno or Nano is easiest for prototyping)
  • Infrared receiver, for example VS1838 will do fine, see also https://arduino-info.wikispaces.com/IR-RemoteControl
  • Breadboard, wiring
  • IR remote control from the aircon/heatpump you plan to decode

Build instructions

Defines for the different brands were introduced to limit the memory footage on a Arduino UNO. Uncomment, in the beginning of the sketch, the define for your remote brand. You will get a compiler error if you forget to uncomment!

  • //#define MITSUBISHI_ELECTRIC
  • //#define FUJITSU
  • //#define MITSUBISHI_HEAVY
  • //#define DAIKIN
  • //#define SHARP_
  • //#define CARRIER
  • //#define PANASONIC_CKP
  • //#define PANASONIC_CS
  • //#define HYUNDAI
  • //#define GREE
  • //#define GREE_YAC
  • //#define FUEGO
  • //#define TOSHIBA
  • //#define NIBE
  • //#define AIRWELL
  • //#define HITACHI
  • //#define SAMSUNG
  • //#define BALLU
  • //#define AUX
  • //#define ZHLT01_REMOTE

Arduino IDE

  • Open the sketch from subdirectory 'rawirdecode' in Arduino IDE and build

PlatformIO

  • platformio.ini contains build definitions for Arduino Mega and ESP32 (tested on M5STACK ATOM LITE)
  • On Mega, connect the receiver data pin to GPIO 2
  • On ESP32, connect the receiver data pin to GPIO 25

Instructions

  • Connect an IR receiver into the Arduino
  • Start the sketch, and enter 1, 2, 3, 4 or 5 into the 'Serial Monitor', to select which timings to use
    • Try out the alternatives until you get sensible output
    • The signal should always start with 'Hh', and within the signal there should only be a couple of 'Hh' pairs (if any)
    • 'H' and 'h' should be there only in pairs 'Hh'
    • 'H' stands for 'header mark' and 'h' for 'header space'
  • Point your IR remote to the IR receiver and send the code
    • If the symbols are known, then the decoder shows its meaning on the serial monitor
    • If the symbols are unknown, then you can help by writing a decoder for the unknown remote

-> Mode '9' can be used to decode known signals, in that case you can send the symbols from the terminal, like entering this:

Hh001101011010111100000111001001010100000000000111000000001111111011010100000001000111001011

Schema

About

Take raw IR signal from a remote receiver and print out pulse lengths

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • C++ 100.0%