meta-lotos

Copyright (c) 2015-2016 ilbers GmbH

LotOS framework layer for Yocto project

LotOS engaged the most popular open source operating systems on a single chip using Mango hypervisor. Based on Yocto, this framework provides a way to build complete image with Linux and FreeRTOS running in Mango virtual machines.

This framework provides better architecture intended to solve many problems in less expensive way. Typical applications of LotOS can be:

• Linux and real-time
• Fast user response after boot
• Software with different safety requirements

Maintainers: Alexander Smirnov [email protected]

Contacts: Mail: [email protected] Skype: ilbers-suport

Environment

The LotOS framework build was tested on the following Linux distributions:

• Fedora 20 (64-bit)
• Fedora 20 (32-bit)
• Debian 7 (32-bit)

Build Targets

The following build targets are available:

• core-image-minimal

  Console-based Linux image with minimal set of tools installed.

• core-image-base

  Console-based Linux image with typical set of tools installed.

• lotos-image-release

  Graphical Linux image with Qt support.

• lotos-image-devel

  The same as above, but with various devel/testing tools

In addition, all the images include Mango hypervisor extensions.

Supported Boards

This layer includes ports for the following boards:

• Banana Pi (A20)

For more information about supported platforms please contact ilbers GmbH.

Project Documentation

For more information about LotOS framework features please refer to the getting started guide:

    doc/getting_started.pdf

Banana Pi Getting Started

LotOS framework uses repo tool simplify project download. If you don't have this tool on your host, please follow this steps to get it.

To build LotOS framework for Banana Pi, the following steps has to be done:

1. Checkout sources:

    $ repo init -u https://github.com/ilbers/lotos-manifest.git
    $ repo sync
   

2. Setup build configuration:

    $ source oe-init-build-env build-folder
   

   Where build-folder is any folder where you want to start build.

3. Edit conf/local.conf in your build folder, line 37:

    MACHINE ??= "bpi-lotos"
   

4. Edit conf/bblayers.conf in your build folder and add overlays, line 8:

    BBLAYERS ?= " \
        /opt/dev/yocto/poky/meta \
        /opt/dev/yocto/poky/meta-yocto \
        /opt/dev/yocto/poky/meta-yocto-bsp \
   

   Add lines:

    /opt/dev/yocto/poky/meta-sunxi \
    /opt/dev/yocto/poky/meta-lotos \
   

   NOTE: replace /opt/dev/yocto by the path to your poky tree.

5. Start build

   $ bitbake lotos-image-release

   The ready SD card image can be found in tmp/deploy/images/bpi-lotos/*.bpi-sdimg