BufferBuddy aims to prevent print quality issues when printing over USB with Octoprint. Designed for Marlin with ADVANCED_OK support, but may work for other firmwares that also support ADVANCED_OK output.
This is a fork from https://github.com/chendo/BufferBuddy for personal use. I'm sharing is case anyone wishes to use it.
WARNING: See details on original page https://github.com/chendo/BufferBuddy**
This plugin requires ADVANCED_OK to function.
-
No longer check if there is command on queue before calling "comm._continue_sending()". Octoprint limits the addition of commands to queue anyway.
-
Changed self.inflight_target to be half of planner_buffer_size. It means we have full planner + 50% on buffer.
-
will check if command_buffer_avail is > 2 as we are going to send an additional command but _monitor thread of Octoprint will also send due to OK received, so we need to have at least 2 spots
-
no longer change _clear_to_send._max user must change _clear_to_send._max to at least 2 on Octoprint interface -- firmware protocol "ok buffer size"
-
On Octoprint code _continue_sending() is limiting the command queue size to 1. The line below needs to be changed on comm.py or the plugin will not work.
while self._active and not self._send_queue.qsize(): -- Change to while self._active and (self._send_queue.qsize() < self._ack_max):
This will set the command queue to the same size as _clear_to_send._max, so it will work as default for all users and only affect those who change "ok buffer size" on the interface. Eventually i will ask for an update on octoprint, but right now you need to change that manually.
- Check your buffer size (BUFSIZE) on Marlin. It should be at least half of planner buffer size (BLOCK_BUFFER_SIZE) + 2 for full usage. most of the times, increrasing BLOCK_BUFFER_SIZE on Marlin is already suficient to reduce buffer problems without using the plugin.
- TX_BUFFER_SIZE needs to be at least 32 for advanced ok. See marlin documentation.
- RX_BUFFER_SIZE - I'm not sure the parameter here, but I believe its better to have at least 2 time the MAX_CMD_SIZE for two commands on buffer. So at least 192. To be sure use 256 or 512 if you can.
This plugin has been tested with Marlin bugfix-2.0.x whti the bellow configurations on BTT SRK 2 and Octoprint 1.7.2 with changes decribed above - _continue_sending(). Marlin config: #define BLOCK_BUFFER_SIZE 64 #define MAX_CMD_SIZE 96 #define BUFSIZE 64 #define TX_BUFFER_SIZE 128 #define RX_BUFFER_SIZE 512 #define ADVANCED_OK #define BAUDRATE 500000
** Important ** Tested using USART connection instead of USB.
** No test was done on resend procedure.
This fork is not on the plugin repository Install from plugin Manager using the link bellow: https://github.com/fflosi/BufferBuddy/releases/download/0.1.1/v0.1.1.zip