Skip to content

Development board for STM32L475. Includes integrated MicroSD reader and connector for W5500 Ethernet module

License

Notifications You must be signed in to change notification settings

llatva/STM32L475-protoboard

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

58 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

STM32L475 protoboard

Development board for STM32L475 (4-layer board). Includes header for W5500 Ethernet module (SPI bus).

JP2 solder jumper needs to be short-circuited to enable USB VBUS detection (not needed if powered only from microUSB connector). Solder jumper needs to be short-circuited to enable USR1 LED. R8 is NOT to be mounted (USB data line pull-up is not used for this MCU type). Fuse pads are for polyswitch fuses. SMD capacitor pads are for A/D LPF (MCU pins have multiple functions).

Boot selection pin (BOOT0) next to the programming connector should be in normal operation shorted to GND (jumper). This means booting from FLASH.

Connector pinouts are documented on the bottom side of the board (programming interface, SPI interface).

See also the daughterboard, in the subdirectory "STM32daughter".

Designed by Lasse OH3HZB 2023

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0).

RevA ERRATA

  • Silkscreen: BOTTOM silkscreen, Ethernet connector's pin next to 3V3 is VDC, not "NC". Actual wiring is correct.

3D

3d

Photo

photo

Schematic

Open with KiCAD (v.7+) or use this PDF.

About

Development board for STM32L475. Includes integrated MicroSD reader and connector for W5500 Ethernet module

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published