Welcome to the Tincoin-Masternode-Setup wiki!
Please Donate to my TIN address if this has been useful to you.
tS2qa28ZHjkFxuLsxMJ2NDGeW5uEqL92C4
Get a VPS from a provider like Vultr using my referal link. https://www.vultr.com/?ref=7362727
Recommended VPS size: 512mb or 1gb RAM
It must be Ubuntu 16.04 (Xenial) - 64bit
If using Vultr, use default settings.
Make sure you have a transaction of exactly 1000 TIN in your desktop cold wallet. This is done by sending yourself 1000 Tin in a single transaction.
Open your wallet on your desktop.
Go to the tab at the bottom that says "Tools"
Go to the tab at the top that says "Debug Console"
Run the following command: masternode genkey
You should see a long key that starts with 7:
7xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
This is your private key, keep it safe, do not share with anyone.
Log into your VPS
Copy command into the VPS command line and hit enter:
wget https://raw.githubusercontent.com/oakey22/Tincoin-Masternode-Setup/master/tincoin-install.sh && chmod +x tincoin-install.sh && ./tincoin-install.sh
When prompted, enter your private key from before.
You will be asked for your VPS IP and a few other questions.
The installation should finish successfully. Ask for help in discord if it doesn't.
Open your wallet on your desktop.
Go to the tab at the bottom that says "Tools"
Go to the tab at the top that says "Console"
Run the following command: masternode outputs
You should see output like the following if you have a transaction with exactly 1000 TIN: { "12345678xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx": "0" }
The value on the left is your txid and the right is the vout
Go the the tab at the bottom that says "Settings"
Click "Open Masternode Configuration File"
Add a line to the bottom of the file using the VPS IP (with port 9859), private key, txid and vout:
mn1 1.2.3.4:9859 7xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx 2345678xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx 0
Save the file, exit your wallet and reopen your wallet.
Go to the tab at the bottom that says "Tools"
Go to the tab at the top that says "Console"
Run the command:
masternode start-alias mn1
Congratulations, your setup should now be complete! Ask for help in discord if you need.
You may see WATCHDOG_EXPIRED till the network picks up the node. This may take around 2 hours.