Welcome to my fork of the Rook DIY 3D Printer by Rolohaun 3D
There were a few tweaks I wished to make to the original project to suit my own needs and make use of some spares.
As stated in the original project, this is a small CoreXY 3D printer with a 120x120 build volume
This is a work in progress, see below for planned modifications
For now no BOM is yet provided for this exact build, but is largely similar to the original BOM here
I am currently still printing pars so all of these mods are currently untested!
- Enclosed frame design so electronics can be housed internally
- 120mm side blower mounts modified from lightbrigade design
- New printbed design to accomodate 120mm heated print beds from AliExpress
- Internal mounts in base for BIGTREEETECH Manta M8P board
- Internal mounts for a Meanwell LRS350 power supply
- Combined cable managment and dual extruder backbox
- IEC power connector
- Support for E3D v6 style hotends (Got a few spares lying around)
- Part cooling fan(s) on print head (removal of 120mm fan)
- Camera mounts on top frame
- RJ45 network port on rear
- WiFi Antenna Mounting