This bootloader implements firmware updating via USB mass storage using the UF2 format. It uses ChibiOS HAL and OS. It currently supports the STM32H7 microcontroller on the Striso board and the ST-Nucleo-H743ZI, and should be easy to port to other boards and microcontrollers.
This bootloader is developed for the Striso board MPE MIDI controller, and borrows parts from the STM32F UF2 bootloader.
- Easy firmware flashing without extra software or hardware, using any device that supports USB flash drives.
- Enter bootloader by holding button on power-up, or enter through soft boot from main firmware.
- INFO_UF2.TXT file containing the current bootloader git revision.
- INFO_FW.TXT file containing the current firmware version (should be at the start of the firmware binary, see Striso control firmware repository for details)
- CONFIG.UF2 and CONFIG.HTM for firmware settings (loaded from firmware).
- Protected flash sector for storing device specific information.
- Failsafe mode for when there are flash ECC errors, started by pressing an extra button on boot.
- CF2 and WebUSB are currently not implemented.
Init submodules.
To build run make -f make/BOARDNAME.make in this folder.
The binaries will be in build/BOARDNAME.
The following files will be built:
bootloader.elf- for use with SWD/JTAG adaptersbootloader.bin- for direct onboard upgradingflasher.uf2- if you already have a UF2 bootloader, you can just drop this on board and it will update the bootloader
It should be relatively easy to port this bootloader to other boards and microcontrollers supported by ChibiOS. Note that the board.c file needs to have a call to pre_clock_init() for the bootloader jump. Also note that for the bootloader to work there need to be multiple flash sectors available, so the STM32H7 value line with only 1 sector of 128kB is not supported.