EMTP-BPA-CPP

C++ translation from EMTP-BPA Fortran using fable
Licensed under the MIT License
Copyright(c) 2021, Dr. Alan W. Zhang

The source codes are compiled under MS Visual Studio 2019 community version.
Set language standard to C++ 17.

1. ConsoleEMTP-BPA.exe

   It takes one input data file to run the program. If no input file was given,
   the program will ask enter the input file name. Assume the input data file name is test.dat, then the program will put log information to test.dat.log and
   output results to test.dat.out in the same folder

   The input data format is described in "EMTP Rule Book" in the Docs folder, or you can try ATPDraw

2. case description

case0001 - single-phase series RLC circuit with step voltage input from "EMTP Primer.pdf"
case0002 - single-phase parallel RLC circuit with capacitor discharge from "EMTP Primer.pdf"
case0003 - RLC circuit from ATP email users using ATPDraw. The atp file using "/" cards
case0004 - LINE CONSTANTS CALCULATIONS, "EMTP Primer.pdf" Section 3, Case 3, 500 kV
case0005 - LINE CONSTANTS CALCULATIONS, "EMTP Primer.pdf" Section 3, Case 3, 345 kV
case0006 - LINE CONSTANTS CALCULATIONS, "EMTP Primer.pdf" Section 3, Case 3, 220 kV
case0007 - Capacitor Switching, "EMTP Primer.pdf" Section 5, Case 5: Capacitor Switch Recovery Voltages
case0008 - Capacitor Switching, "EMTP Primer.pdf" Section 5, Case 5: Back-to-Back Capacitor
Banks With Current-Limiting Reactors case0009 - Capacitor Switching, "EMTP Primer.pdf" Section 5, Case 5: Restrike Simulation
case0010 - Steady-state solution with a fault, "EMTP Primer.pdf" Section 6, Case 6: Parallel EHV Line
Resonance case0011 - Reclosing Of Transmission Lines, "EMTP Primer.pdf" Section 7, Case 7
case0012 - Lightning surge studies, "EMTP Primer.pdf" Section 4, Case 4