F5 module

Based off the f5 module from puppetlabs (https://github.com/puppetlabs/puppetlabs-f5)

Overview

This is based on the puppetlabs-f5 module, amongst others it adds the following extras:

• Support for F5 V11+. As of writing the puppetlabs-f5 module also has added V11 support
• Prefetch methods.
• F5 transactions and provider flush methods for atomic changes (where possible).
• Partition support per resource.
• Autorequirement of dependencies.

Supported resources:

• f5_file
• f5_irule
• f5_node
• f5_partition
• f5_pool
• f5_poolmember
• f5_virtualserver

Usage

1. Create F5 Device configuration file in $confdir/device.conf (typically /etc/puppet/device.conf or /etc/puppetlabs/puppet/device.conf)

    [f5.example.com]
    type f5
    url https://username:password@address/
   

2. Create the corresponding node configuration on the puppet master site.pp:

    node f5.example.com {
   
      f5_partition { '/TestPartition2000': }
    
      f5_pool { '/TestPartition2000/TestPool2000':
        lb_method       => 'ratio_member',
        health_monitors => ['/Common/https', '/Common/http'],
        members         => [
          {'address' => '/TestPartition2000/TestNode2001', 'port' => 80},
          {'address' => '/TestPartition2000/TestNode2002', 'port' => 80},
          {'address' => '/TestPartition2000/TestNode2003', 'port' => 80},
          {'address' => '/TestPartition2000/TestNode2004', 'port' => 80},
        ]
      }
    
      f5_node {
        '/TestPartition2000/TestNode2000':
          connection_limit => 1,
          dynamic_ratio    => '1',
          ipaddress        => '1.1.1.97',
          rate_limit       => 1,
          ratio            => 1,
          session_status   => 'ENABLED';
        '/TestPartition2000/TestNode2001':
          ipaddress => '2.2.2.2';
      }
    
      f5_poolmember { '/TestPartition2000/TestNode2000':
        port        => 443,
        pool        => '/TestPartition2000/TestPool2000',
        ratio       => 2;
      }
    
      f5_poolmember { '/TestPartition2000/TestPool2000:/TestPartition2000/TestNode2001':
        port             => 443,
        connection_limit => 100,
        ratio            => 7;
      }
    
      f5_irule { '/TestPartition2000/TestRule2000':
        definition => '#Empty';
      }
    
      f5_virtualserver { '/TestPartition2000/TestVirtualServer2000':
        address                      => '1.2.3.4',
        default_pool                 => '/TestPartition2000/TestPool2000',
        port                         => '443',
        profiles                     => ['/Common/http', '/Common/clientssl', '/Common/serverssl'],
        protocol                     => 'TCP';
      }
    }
   

3. Execute puppet device command:

    $ puppet device
   

4. To test from commandline:

    $ FACTER_url=https://admin:[email protected]/ puppet resource f5_irule