ESP32-S3 Display Project (surfPrevisions) - WIP

requeriments:

• USB-C Cable OTG
• Lilygo T-DISPAY-S3 Board

SETUP PROJECT

1. Install Arduino IDE

2. In Arduino Preferences, on the Settings tab, enter the https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json URL in the Additional boards manager URLs input box.

3. Download Espressif Boards Manager Version esp-32 <= 2.0.11 (https://forum.arduino.cc/t/esp32-s3-sudden-compile-error/1177237/22) / (Bodmer/TFT_eSPI#3329)

4. Download T-Display-S3 , move to Arduino library folder (e.g. C:\Users\YourName\Documents\Arduino\libraries)

5. Copy TFT-eSPI to Arduino library folder (e.g. C:\Users\YourName\Documents\Arduino\libraries)

6. Open ArduinoIDE ,Tools ，Make your selection according to the table below

   Arduino IDE Setting	Value
   Board	ESP32S3 Dev Module OR
   	LilyGo T-Display-S3
   Port	Your port
   USB CDC On Boot	Enable
   CPU Frequency	240MHZ(WiFi)
   Core Debug Level	None
   USB DFU On Boot	Disable
   Erase All Flash Before Sketch Upload	Disable
   Events Run On	Core1
   Flash Mode	QIO 80MHZ
   Flash Size	16MB(128Mb)
   Arduino Runs On	Core1
   USB Firmware MSC On Boot	Disable
   Partition Scheme	16M Flash(3M APP/9.9MB FATFS)
   PSRAM	OPI PSRAM
   Upload Mode	UART0/Hardware CDC
   Upload Speed	921600
   USB Mode	CDC and JTAG

   • The options in bold are required, others are selected according to actual conditions.

7. Turn-on the Board pressing boot button

DATA GENERATE EVERY HOUR WITH GITHUB ACTIONS / STOPPED

barrinha.json