dc motor controller
wout zweers enschede NL www.woutzweers.nl www.wowlab.nl [email protected]
created to develop software for 12V 25A DC motor controller
introduction:
To control a dc motor several ways are feasible. In general however one method that can be used over and over for different motors is efficient working. It will then not be the best solution for all situations but if the controller is powerfull enough to work for many situations this is acceptable and efficient in the long run.
a suitable controller was found in the powerfull Parallax HB25 controller. This can be controlled conveniently with the cheap arduino (or similar) microcontroller The software for this controller can be developed cheaply.
this controller receives puls length coded steering signals, similar to servo controller signals. the arduino sends a puls with the appropriate legth to the driver, and the arduino itself can receive various kinds of signals: puls length, -100_ +100%, forward, neutral, backward etc. The code for the arduino is developed as an arduino sketch and uploaded (flashed) through the serial port. After that the arduino can function on itself. The signal provided however must be appropriate for this and it is generated with a processing sketch (program) which runs on the computer.
this repository contains a combination of arduino sketches for the arduino and processing sketches to be used on the pc or mac
list of materials:
controller: parallax HB 25 motor controller https://www.parallax.com/product/29144
motor: any 12V DC motor.
ballast: 12V 1A bulb, for low-amps dc motors
arduino: uno nano or similar clone download softwar: http://www.arduino.cc/en/Main/Software
processing download processing: https://processing.org/download/
12V DC power source (used: velleman labps3005D lab power supply or similar) http://www.velleman.eu/products/view/?id=417862
