RaspberryPi Software Configuration

6LBR on the RaspberryPi should work with any Linux distribution, but it has been extensively tested with the Raspbian distribution, which is a debian-based operating system optimized for the RaspberryPi. We provide several ways to get started with 6LBR on the RPi:

• Method 1: Install 6LBR on an existing Raspbian image following the instructions on this page. This supposes that you already have an existing installation of Raspbian on an SD card, or that you would like to install one from the official Raspbian repository. In any case, refer to the Raspbian documentation for information on how to install raspbian.
• Method 2: Use The Instant Border Router a full SD Card image based on Raspbian already with 6LBR already pre-installed

Manual Installation using .deb packages

6LBR can be installed using .deb packages. You can either build the packages yourself, or download the .deb file hosted on the 6LBR project website.

Download binaries package

Download the 6lbr package on the RPI if you do not plan to build it yourself:

wget ……..cetic-6lbr-1.0-0_armhf.deb

Dependencies

If you intent to use tap-bridging, you need to install bridge-utils :

apt-get install bridge-utils

Specific Configuration for USB Slip-Radio motes

Due to a limitation in the kernel serial driver in the current Raspian distribution, you need to modify the system configuration. In the boot partition, open the /boot/cmdline.txt file and add the following configuration parameter :

dwc_otg.speed=1

This enables the support for the high baudrate usb-serial SLIP connector with the slip-radio mote.

Specific configuration for the Nooliberry radio

The Nooliberry radio communicates at 38400 baud over the UART.

• remove the following parameters from /boot/cmdline.txt
  

  console=ttyAMA0,115200 kgdboc=ttyAMA0,115200

• note that you do not need dwc_otg.speed=1 in that file for the Nooliberry, due to the lower baudrate
• Also, in /etc/inittab the following line at the bottom of the file should be commented out, because the Nooliberry needs to use the ttyAMA0:
  

  #Spawn a getty on Raspberry Pi serial line
  
  #T0:23:respawn:/sbin/getty -L ttyAMA0 115200 vt100

Installation

• Install it :
  

  dpkg -i cetic-6lbr-1.0-0_armhf.deb 

• Update the configuration files as needed
• Start the daemon
  

  /etc/init.d/6lbr start

Binaries and package creation from sources (optional)

If you would rather build the packages yourself,

1. On your RPi, obtain the latest version of 6LBR:

apt-get update
apt-get install git
git clone https://github.com/cetic/6lbr
cd 6lbr/examples/6lbr

2. In 6lbr source directory, do the following commands (you have time for a coffee):

make all_native
make tools

3. Install directly using the following command :

make install

4. Or build and install using a .deb package :

make rpi_deb

5. The new .deb package should be created

Instant Border Router (coming soon)

TODO