Add AW lock register to handle W FIFO push signal (openhwgroup#2461)

Signed-off-by: Nils Wistoff <[email protected]>

core/cache_subsystem/std_cache_subsystem.sv

@@ -133,6 +133,8 @@ module std_cache_subsystem
   logic [1:0] w_select, w_select_fifo, w_select_arbiter;
   logic [1:0] w_fifo_usage;
   logic w_fifo_empty, w_fifo_full;
+  logic w_fifo_push, w_fifo_pop;
+  logic aw_lock_q, aw_lock_d;
 
 
   // AR Channel
@@ -188,17 +190,26 @@ module std_cache_subsystem
       .flush_i   (1'b0),
       .testmode_i(1'b0),
       .full_o    (w_fifo_full),
-      .empty_o   (),                                                          // leave open
+      .empty_o   (),               // leave open
       .usage_o   (w_fifo_usage),
       .data_i    (w_select),
       // a new transaction was requested and granted
-      .push_i    (axi_req_o.aw_valid & axi_resp_i.aw_ready),
+      .push_i    (w_fifo_push),
       // write ID to select the output MUX
       .data_o    (w_select_fifo),
       // transaction has finished
-      .pop_i     (axi_req_o.w_valid & axi_resp_i.w_ready & axi_req_o.w.last)
+      .pop_i     (w_fifo_pop)
   );
 
+  always_ff @(posedge clk_i or negedge rst_ni) begin : aw_lock_reg
+    if (~rst_ni) aw_lock_q <= 1'b0;
+    else aw_lock_q <= aw_lock_d;
+  end
+
+  assign w_fifo_push = ~aw_lock_q & axi_req_o.aw_valid;
+  assign w_fifo_pop = axi_req_o.w_valid & axi_resp_i.w_ready & axi_req_o.w.last;
+  assign aw_lock_d = ~axi_resp_i.aw_ready & (axi_req_o.aw_valid | aw_lock_q);
+
   // In fall-through mode, the empty_o will be low when push_i is high (on zero usage).
   // We do not want this here. Also, usage_o is missing the MSB, so on full fifo, usage_o is zero.
   assign w_fifo_empty = w_fifo_usage == 0 && !w_fifo_full;