-
Notifications
You must be signed in to change notification settings - Fork 29
buildwm8731
mxmxmx edited this page Feb 14, 2016
·
25 revisions
you can follow the values indicated on the pcb. no special precautions required. except, ideally use 10nF caps (NP0) where it says 1nF (around the MCP6002s).
here is the component overlay.
- note: the four unlabelled 0603 pads close by the 2x20 header is where the ferrite beads go (BLM18BB221SN1D); regular 220R will do, alternatively.
- note: the 2x20 header you see in the above pictures is suitable only for models A+ and zero; pi 2 will need a taller socket, obviously!
- make sure you bend over the caps ...
- the
+
next to the one tact switch is where pin 3 (anode) of the 5GTH93542 part goes: