-
Notifications
You must be signed in to change notification settings - Fork 139
Configuring SerialNumberUpdateTask
Endi S. Dewata edited this page Oct 7, 2024
·
5 revisions
This page describes the process to configure SerialNumberUpdateJob for Sequential Serial Numbers.
By default, the SerialNumberUpdateTask will run every 10 minutes.
To change the interval, specify the following parameter in the CA’s CS.cfg:
ca.serialNumberUpdateInterval=<seconds>
If the value is 0 or negative, the task will be disabled.
|
Tip
|
To find a page in the Wiki, enter the keywords in search field, press Enter, then click Wikis. |